Click here to visit the Tuff Rider website. Get A Zolatone AIM Catalog Contact Zolatone Automotive, Industrial, and Marine Zolatone AIM Home Page Click here to visit the Tuff Rider website. Click here to visit Zolatone's SeaLife page. Frequently Asked Questions Environmental Compliance and Warranty Manufacturer's Safety Data Sheets Spray Equipment and Methods of Applying Zolatone Zolatone 20 Series Specifications Understanding Zolatone Coatings Zolatone Intermix Program Zolatone Primers Zolatone Zo-Pol Epoxy Clear Coat Zolatone Power Spray Kit Zolatone Strippable Booth Coat Zolatone 20 Series Multicolor
 
ZOLATONE 9251-000C Quick Step Catalyst
9251-000C Quick Step Catalyst is specifically formulated to use with Zolatone 20 Series (Automotive, Industrial & Marine) multicolor products to enhance water and chemical resistance without sacrificing adhesion or impact resistance. Zolatone 20-Series w/ Quick Step Catalyst is designed for use over ferrous metals, nonferrous metals, fiberglass, plastic and woods etc. The use of appropriate surface preparation methods and primer(s) will be necessary. The use of this catalyst is optional, and is to be used only if higher performance of Zolatone 20 Series multicolor is desired. Consult with a Zolatone AIM representative before using.
Part No. Description
9251-000C-HP Quick Step Catalyst for Zolatone 20 Series

Technical Information

Application:
• Over properly prepped and primed surface; Select the proper primer / sealer base color for the Zolatone finish color. Refer to the Zolatone 20 Series pages or page 2 of the Quick Step Catalyst Technical Data Sheet.
• Use a pressure pot system with a conventional or HVLP spray gun with a fluid tip of .080 to .090 inch or 2.0 to 2.4 mm.
• Apply Zolatone in a two step process. Sheer Coat followed by Pattern Coat.
Sheer Coat: Spray gun 12 inches from surface with fluid needle valve nearly in the closed position.
Conventional Gun Air Pressure: 50-60 psi.
HVLP Gun Air Pressure: 40-50 psi.
Pot/Fluid Pressure: 10 psi (assumes 2 Liter pressure pot is used)
Pattern Coat: Total film thickness not to exceed 8 mils wet film thickness. Spray gun 24-36 inches from surface with fluid needle valve opened one turn from step above. Conventional Gun Air Pressure: 20-30 psi. HVLP Gun Air Pressure: 20-30 psi. Pot/Fluid Pressure: 10 psi (assumes 2 Liter pressure pot is used)
Please see the Zolatone 20 Series pages for more application and technical information!
Technical Data:
• Mix Ratio 16:1
• Pot Life at 70% F 50% RH: Maximum 8 Hrs.
Flash Point:
23°F
V.O.C.:
 V.O.C. Catalyst – 265 g/l, V.O.C of Coating – Zolatone 20 Series – 680 g/l, V.O.C. of Material – Zolatone 20 Series – 483 g/l
V.O.C. Mixed 16/1, V.O.C. Of Coating – 642 g/l, V.O.C. Of Material – 471 g/l
Air Dry Times:
To Touch – 2 hours air dry at 70°F and 50% humidity.
To Use – (light) overnight.
Full Cure – achieved in 5-7 days.
Tape Free – overnight.
Force Dry:
Force dried at 140°F in 30-60 minutes. Allow 30 minutes flash time if using force air or baking. Can be clear coated (optional) after cooling.
© Quest Specialty Chemicals, Inc. 2006-2007 All Rights Reserved